STEP 5 - PRIMING THE GROUP HEAD
• Before placing the filter holder into
position, it is recommended to run a
short flow of water through the group
head.
• Place a container or empty cup under
the group head.
• With the filter holder removed, prime
the group head by pressing and holding
down the single or double cup button
for approximately 5 seconds.
Refer to
‘Manual Espresso’, page 18.
A pumping noise will be heard during
this operation, and water will run through
the group head.
STEP 6 - INSERTING THE FILTER HOLDER
Place the filter holder underneath the
group head so that the handle is aligned
with the insert graphic. Insert the filter
holder up into the group head and rotate
the handle to the right until resistance is
felt, this will be at an approximate 90°
angle to the machine.
STEP 7 – BREWING THE COFFEE
• Ensure all the button surrounds on the
control panel are illuminated, indicating
the machine has reached the correct
temperature for brewing, and is ready for
use.
• Ensure the drip tray and filter holder are
in place.
• Place one or two pre-warmed cups
beneath the filter holder outlet.
PROGRAMMED ESPRESSO – ONE CUP
Press the one cup button once. After a
few seconds, aromatic coffee will begin to
pour into the cup. A pumping noise will be
heard in this operation. The machine will
automatically stop once the preset pour
has been delivered.
OPERATING YOUR BREVILLE DIE CAST PROGRAMMABLE ESPRESSO MACHINE (continued)
Comments to this Manuals